Op dinsdag 25 november 2014 14:09:06 schreef u:
> On 25/11/14 09:32, Freek de Kruijf wrote:
> > Op dinsdag 25 november 2014 04:00:44 schreef Sid Boyce:
> >> I use large sizes of SD cards.
> >>
> >> After burning the image, e.g to /dev/sdb, remove the SD card and insert
> >> it again.
> >>
> >> "gparted /dev/sdb"
> >>
> >> Add the space of the rootfs partition to the unused space and change
> >> rootfs to the total calculated, click resize and Apply.
> >> Regards
> >> Sid.
> >
> > I did that on a 16 GB card and removed /var/lib/YaST2/reconfig_system in
> > order to be able to use it headless, but that did not work.
> > However putting the freshly burned image in the RPi removing the card a
> > little later from the RPi, removing /var/lib/YaST2/reconfig_system and
> > reinserting the card in the RPi gave me a working system, accessible via
> > ssh and with a large rootfs. There is also a swap partition at the end of
> > about 500 MiB. Will try to remove that reconfig file right after burning
> > to see if I get a working headless system with expanded rootfs.
>
> That's strange as I have always done it that way on Beaglebone,
> Pandaboard, ODROID-X, ODROID-U3 and Parallella-16.
>
> I always do "fsck -a /dev/sdb[12]" after resizing and on the odd
> occasion it reports that it cleared a dirty bit on the VFAT partition.
> Successfully boots every time.
> Regards
> Sid.
When applying the 13.2 image on the SD card, now there are three partitions on
the card. A FAT partition, an ext3 partition and the rootfs is ext4. After
initial use on the RPi there is a fourth partition at the end, a swap
partition. So are we talking about the same type of image, a 13.2 image?
I tried the procedure to remove the reconfig file right after burning and
before actually using the card in the RPi, but that did not work. Did not do a
"fsck -a /dev/sdg{123}" after burning. Should I?
BTW. I noticed a change in naming of the image, first I used:
openSUSE-13.2-ARM-JeOS-raspberrypi.armv7l-1.12.1-Build29.4.raw.xz
now I use:
openSUSE-13.2-ARM-JeOS-raspberrypi.armv6l-1.12.1-Build30.1.raw.xz
If I am right the architecture of the RPi is armv6l and not armv7l, isn't it?
So now we have a properly named image?
--
fr.gr.
member openSUSE
Freek de Kruijf
--
To unsubscribe, e-mail: [email protected]
To contact the owner, e-mail: [email protected]
