On 01/26/2015 12:28 PM, Stefan Botter wrote:
Hi Oscar,
On Mon, 26 Jan 2015 10:19:09 +0100
Oscar C <[email protected]> wrote:
El 2015-01-25 11:44, Stefan Botter escribió:
Hi all,
I am trying to run the cubietruck JeOS image from
d.o.o://ports/armv7hl/factory/images/, but so far without success.
I have the image on a sd card, and put both partitions also on a
connected sata disk. As far as I can see the kernel starts, but
everything comes to a sudden stop where - I believe - the
init/systemd
process should take over.
I also tried the 13.2 image, but that did not work either, for sure
because of the uboot version (mentioned here on the list earlier).
Is there any magic to perform? Can I help?
Could you attach the output of the serial console?
The attached file is the log from reset of the board until the system
is stuck, and after a reset I stoped the boot process and print the
environment.
Please tell me, if you need more information.
I used
openSUSE-Factory-ARM-JeOS-cubietruck.armv7l-1.12.1-Build257.8.raw.xz
downloaded last Friday.
[ 4.349256] ahci-5v: 5000 mV
[ 4.352838] usb1-vbus: 5000 mV
[ 4.356408] usb2-vbus: 5000 mV
[ 4.360052] vmmc3: 3300 mV
[ 4.363104] sunxi-rtc 1c20d00.rtc: setting system clock to
2085-01-26 11:23:16 UTC (3631346596)
[ 4.371840] sr_init: No PMIC hook to init smartreflex
[ 4.377113] sr_init: platform driver register failed for SR
[ 4.388375] Unable to find PPMU node
[ 4.392071] exynos5-bus-int: probe of exynos5-bus-int failed with
error -2
[ 4.399082] vmmc3: disabling
[ 4.401997] usb2-vbus: disabling
[ 4.405223] usb1-vbus: disabling
[ 4.408464] ahci-5v: disabling
[ 4.411516] vcc3v3: disabling
[ 4.414492] vcc3v0: disabling
This is where it stops. As a rough guess, maybe the 3v line is the one
driving the CPU? :)
Alex
--
To unsubscribe, e-mail: [email protected]
To contact the owner, e-mail: [email protected]
