Am Freitag, 19. Juni 2015, 14:36:59 schrieb Fabian Vogt: > Am Freitag, 19. Juni 2015, 14:07:59 schrieben Sie: > > Am 18.06.2015 um 20:24 schrieb Fabian Vogt: > > > Am Donnerstag, 18. Juni 2015, 13:20:42 schrieb David Byte: > > >> In trying to chase down the issue on my RPi 2 and the graphics I > > >> performed a zypper up (93 packages). After giving a serious wait (20 > > >> minutes or so), I issued a reboot command. > > >> > > >> Now, the system will not boot. Thoughts? > > > I had the same issue yesterday (it may be a different issue now, though): > > > the new 3.18.14-1-rpi2 kernel does somehow lack support for the sdhci > > > driver, > > > so the SD card is not recognized anymore. Just change the symlinks > > > in the second partition back to the old 3.18.9-3-rpi2 kernel and initrd > > > and it should work again. > > > > Are you sure it's the kernel's fault? Or could it be that the initrd is > > not including the module? You may need to add it in > > /etc/sysconfig/kernel to INITRDMODULES. > I did a zypper dup like David did and the resulting kernel doesn't print the > "Load BCM2835 MMC driver" message on boot > although "CONFIG_MMC_BCM2835=y" is in the config file. > > Dracut says "Failed to install module sdhci_bcm2835", > but that's expected as it's not configured as a module and > it's the exact same for the working 3.18.9-3-rpi2 kernel. > > I'm currently trying a zypper dup with the new kernel-rpi2-3.18.14-1.2 version > zypper found just now and I'm getting a long list of file conflicts because > the > /lib/modules/3.18.14-1-rpi2 directory is used by kernel-rpi2-3.18.14-1.1 as > well. Just tried to boot it, same issue.
> > > Regards, > > Andreas -- To unsubscribe, e-mail: [email protected] To contact the owner, e-mail: [email protected]
