Op zaterdag 19 november 2016 10:14:32 schreef Freek de Kruijf: > Op zaterdag 19 november 2016 09:46:04 schreef Freek de Kruijf: > > I did tests with images from the above site on: > > openSUSE-Tumbleweed-ARM-JeOS-raspberrypi3.aarch64-2016.11.15-Build7. > > [4-6].raw.xz > > > > All did show the Grub boot screen and continued, but stopped with a > > message > > on my TV screen as in the attached photo. > > The last image I tested from this source, I believe, that did work was: > openSUSE-Tumbleweed-ARM-JeOS-raspberrypi3_aarch64.aarch64-2016.10.18- > Build7.9.raw.xz > > The same message appeared as reported in my first message, but a few minutes > later the system continued and after about 10 minutes the system prompt > appeared on the screen. In the previous tests I did wait at least that > long. > > It even booted with a USB storage device attached.
I went on with this image and did a "zypper up --no-recommends". All went well and a reboot was very fast, even the scan on USB storage. A following reboot however, was not successful; scanning for the USB storage hung up the system, however unplugging the power and plugging in it again did boot the system again. So I decided to continue with installation of kernel-default-4.8.8-1.1 and dtb-broadcom-4.8.8-16.2 from openSUSE-Ports-Tumbleweed-repo-oss replacing these packages from Factory-Contrib-RPi3, which does not provide anything anymore. This was successful. Also some packages for Wi-Fi were loaded. However the Wi-Fi device is still not visible nor is the bluetooth device. -- fr.gr. member openSUSE Freek de Kruijf -- To unsubscribe, e-mail: [email protected] To contact the owner, e-mail: [email protected]
