On Wed 15 Feb 2017 06:21:25 PM CST, Malcolm wrote: >On Thu 16 Feb 2017 12:19:15 AM CST, Alexander Bergmann wrote: > >>Hi everyone, >> >>I've ran into a problem where the wifi card of my Raspberry Pi 3 can >>not be initialized after I've executed mkinitrd. >> >>I've used the latest JeOS Leap42.2 image. >> >>openSUSE-Leap42.2-ARM-JeOS-raspberrypi3.aarch64-2017.02.02-Build1.5.raw.xz >> >>When I start the image the WiFi card will be loaded without any >>problems. >> >>> brcmfmac: brcmf_sdio_drivestrengthinit: No SDIO Drive strength init >>> done for chip 43430 rev 1 pmurev 24 brcmfmac: brcmf_c_preinit_dcmds: >>> Firmware version = wl0: May 27 2016 00:13:38 version 7.45.41.26 >>> (r640327) FWID 01-df77e4a7 brcmfmac: brcmf_cfg80211_reg_notifier: >>> not a ISO3166 code >> >>After a simple mkinitrd the module cannot be loaded anymore. >> >>> brcmfmac_sdio: probe of mmc1:0001:1 failed with error -110 >>> brcmfmac_sdio: probe of mmc1:0001:2 failed with error -110 >> >>I couldn't find out so far what caused this problem. >> >>Anyone any hint/idea? >> >>Ciao, >>Alex~ >> >Hi >I just followed the steps in the following archive message on a Leap >42.2 JeOS install (except I just used mkinitrd) >https://lists.opensuse.org/opensuse-arm/2016-11/msg00018.html > >Wireless is up. > Hi (again) One other thought, is the time/date configured? I've seen some funnies if it's not set, prefer to use ntp...
-- Cheers Malcolm °¿° SUSE Knowledge Partner (Linux Counter #276890) openSUSE Leap 42.1|GNOME 3.16.2|4.1.36-44-default up 4 days 21:00, 3 users, load average: 0.17, 0.09, 0.12 CPU AMD Athlon(tm) II X4 635 @ 2.90GHz | GPU Nvidia GeForce 8800 GT -- To unsubscribe, e-mail: [email protected] To contact the owner, e-mail: [email protected]
