On Freitag, 17. Februar 2017 21:08:49 CET Alexander Bergmann wrote: > Hi everyone, > > I have two RPi3 boards here. One was purchased directly when it came out > beginning of 2016, the second one around half a year later.
The newer one probably has a newer bootrom, they added support for e.g. USB boot after the initial shipments. > I mainly used the second one for openSUSE testing. Just now I wanted to > do the same with the first board but I'm unable to boot into the system. > The boot sequence is interrupted right after grub and then the system > starts again from the beginning, cycling forever. > > Both boards have a similar layout with V1.2 written onto it. So I have > no idea where to start to identify this issue. > > Anyone any idea? Have you tried grabbing the output from the serial console? Either using a USB-serial converter, or connect the two PIs, GND straight, UART RX/TX crossed. Kind regards, Stefan -- Stefan Brüns / Bergstraße 21 / 52062 Aachen home: +49 241 53809034 mobile: +49 151 50412019 work: +49 2405 49936-424 -- To unsubscribe, e-mail: [email protected] To contact the owner, e-mail: [email protected]
