Am 12.07.19 um 17:53 schrieb Knurpht-openSUSE:
> Op vrijdag 12 juli 2019 16:35:33 CEST schreef Bernd Nachtigall:
>> After I install
>> openSUSE-Leap-15.1-ARM-XFCE-raspberrypi3.aarch64-2019.05.17-Snapshot1.18.raw
>> .xz to a RasPi I get a IP via DHCP during the first boot.
>>
>> Then I configure a fix IP via YaST. But this fix IP is configured as
>> secondary IP. Even if I remove the interface configuration and renew it
>> with the fix IP - after the YaST config runs throught, there are a
>> interface with a primary addess from DHCP and a additional secondary IP
>> from the fixed config.
>>
>> Where i can change this tricky behavior?
>>
>> Bernd
> Please show some confirmation:
> ip addr
>
>
mon:/etc/sysconfig/network # ip a s
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN
group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast
state UP group default qlen 1000
link/ether b8:27:eb:8d:5b:c2 brd ff:ff:ff:ff:ff:ff
inet 192.168.250.181/25 brd 192.168.250.255 scope global
noprefixroute dynamic eth0
valid_lft 2816sec preferred_lft 2816sec
inet 192.168.250.185/25 brd 192.168.250.255 scope global secondary
noprefixroute eth0
valid_lft forever preferred_lft forever
inet6 fe80::c369:b4f2:7cdc:133c/64 scope link noprefixroute
valid_lft forever preferred_lft forever
3: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast
state DOWN group default qlen 1000
link/ether d2:f6:86:b8:bd:70 brd ff:ff:ff:ff:ff:ff
With this config it is not possible to connect to the I-Net. When I
delete .181 the connection is possible but after a while dhcp is rising
again.
Bernd
--
To unsubscribe, e-mail: [email protected]
To contact the owner, e-mail: [email protected]
