Donn Washburn wrote:
OpenSuSE 10.3 Alpha 2 CDs from isos
I have noticed on about every recent complete new install (not upgrade).
Yast fails if a network connection is NOT available. I currently am
loading a unit that has NO network connection to a modem or network
card/device. If I tell Yast to NOT check the network, it hangs.
If I reboot, Yast comes up at a point prior to runlevel load, at the
point prior to setting the "root" password and where Zenworks wants to
sync. Yast fails at the point just after setting the network to "skip"
or when assigned (static IP, resolv.conf, and gateway).
It also leaved any tty in "#" without a password.
This was solved by deleting all mention of any network device. It does
still seem that the "Configuration > Network > Skip" function doesn't
always work. It bails out and doesn't complete if you finally kill the
process (as a last resort.
--
73 de Donn Washburn
307 Savoy Street Email: " [EMAIL PROTECTED] "
Sugar Land, TX 77478 LL# 1.281.242.3256
Ham Callsign N5XWB HAMs : " [EMAIL PROTECTED] "
VoIP via Gizmo: bmw_87kbike / via Skype: n5xwbg
BMW MOA #: 4146 - Ambassador
" http://counter.li.org " #279316
Did you know?
The transistor was invented by three white men.
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
