Currently using 10.3A5 on my laptop and trying to get my Linksys wireless "G" card to work.Worked great up through 10.1 (skipped 10.2). The card is a Linksys 54G card with the BCM4306 chipset. I have installed the firmware using fw-cutter. I get the following with dmesg when inserting the card:
Jun 24 16:35:21 lt1720 kernel: pccard: CardBus card inserted into slot 0 Jun 24 16:35:21 lt1720 kernel: PCI: Enabling device 0000:03:00.0 (0000 -> 0002) Jun 24 16:35:21 lt1720 kernel: ACPI: PCI Interrupt 0000:03:00.0[A] -> Link [LNKD] -> GSI 10 (level, low) -> IRQ 10 Jun 24 16:35:21 lt1720 kernel: PCI: Setting latency timer of device 0000:03:00.0 to 64 Jun 24 16:35:21 lt1720 kernel: bcm43xx: Chip ID 0x4306, rev 0x3 Jun 24 16:35:21 lt1720 kernel: bcm43xx: Number of cores: 5 Jun 24 16:35:21 lt1720 kernel: bcm43xx: Core 0: ID 0x800, rev 0x4, vendor 0x4243 Jun 24 16:35:21 lt1720 kernel: bcm43xx: Core 1: ID 0x812, rev 0x5, vendor 0x4243 Jun 24 16:35:21 lt1720 kernel: bcm43xx: Core 2: ID 0x80d, rev 0x2, vendor 0x4243 Jun 24 16:35:21 lt1720 kernel: bcm43xx: Core 3: ID 0x807, rev 0x2, vendor 0x4243 Jun 24 16:35:21 lt1720 kernel: bcm43xx: Core 4: ID 0x804, rev 0x9, vendor 0x4243 Jun 24 16:35:21 lt1720 kernel: bcm43xx: PHY connected Jun 24 16:35:21 lt1720 kernel: bcm43xx: Detected PHY: Analog: 2, Type 2, Revision 2 Jun 24 16:35:21 lt1720 kernel: bcm43xx: Detected Radio: ID: 2205017f (Manuf: 17f Ver: 2050 Rev: 2) Jun 24 16:35:21 lt1720 kernel: bcm43xx: Radio turned off Jun 24 16:35:21 lt1720 kernel: bcm43xx: Radio turned off Jun 24 16:35:22 lt1720 ifup: eth1 device: Broadcom Corporation BCM4306 802.11b/g Wireless LAN Controller (rev 03) Jun 24 16:35:22 lt1720 ifup: eth1 configuration: wlan-bus-pcmcia Jun 24 16:35:22 lt1720 kernel: bcm43xx: PHY connected Jun 24 16:35:22 lt1720 kernel: bcm43xx: Microcode rev 0xef, pl 0xe (2003-07-10 18:59:06) Jun 24 16:35:22 lt1720 kernel: bcm43xx: Radio turned on Jun 24 16:35:22 lt1720 kernel: bcm43xx: Radio enabled by hardware Jun 24 16:35:22 lt1720 kernel: bcm43xx: Chip initialized Jun 24 16:35:22 lt1720 kernel: bcm43xx: 30-bit DMA initialized Jun 24 16:35:22 lt1720 kernel: bcm43xx: Keys cleared Jun 24 16:35:22 lt1720 kernel: bcm43xx: Selected 802.11 core (phytype 2) Jun 24 16:35:22 lt1720 ifup-dhcp: Starting DHCP Client Daemon on eth1... Jun 24 16:35:22 lt1720 ifup-dhcp: . Jun 24 16:35:23 lt1720 ifup-dhcp: . Jun 24 16:35:24 lt1720 ifup-dhcp: . Jun 24 16:35:25 lt1720 ifup-dhcp: . Jun 24 16:35:26 lt1720 ifup-dhcp: . Jun 24 16:35:27 lt1720 ifup-dhcp: no IP address yet... backgrounding. I also get a repeating error as follows in the messages file: Jun 24 16:27:08 lt1720 kernel: CCMP: received packet without ExtIV flag from 00:12:17:38:ed:08 At this point nothing further takes place, no network address and no routing setup. Any suggestions? Is this a known problem? Change to a different card? Report it to bugzilla? Give up using a computer? :-) --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
