2005/10/10, houghi <[EMAIL PROTECTED]>:
> On Mon, Oct 10, 2005 at 09:40:44AM +0300, Jukka wrote:
> > Thanks for your tip! I try it next time I am at home (writing this
> > from work), but refresh rate is correct (according to monitor manual)
> > and my past experiences with Suse (I have used it since version 7.1),
> > with other linux distributions and with Win98 has had no problems?
> > Even it would work, I think it is not a solution because monitor is
> > capable for 1600x1200 resolution??
>
> Look at the refresh rate. f it is set at 85, perhaps 75 will work.
> I used to have a CRT monitr that could do 1600x1200, but I had to go to a
> lower refreshrate then if it were at 1024x768 even though the manual did
> not mention this.
>
> Just start with the lowest possibilaties and work your way up.
>
> houghi
Problem solved! Monitor/model was not recognized automatically until
OpenSuse (so I thought everything should be right after the
installation) but when I checked values again, I realized that only
*model* was right, but manufacturer was not (it should have been
"Hitachi", but it was "HTC" - I suppose that means something else than
Hitachi??). I entered windows INF-disk ("Hitachi Monitor INF Disk for
Windows) and everything seems to work now. Should I report this to
someone?
-Jukka
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
