Hi, Thanks but i just want my connection started every boot time.The command is this:
dhpcpd wlan0 Where to put it ? Also, if i try to configure my card with Yast, system screws up and never connect ot the net again, thanks again to Cisco systems. On 11/1/05, Guðlaugur Jóhannesson <[EMAIL PROTECTED]> wrote: > > Ilker wrote: > > After every boot, i have to type "dhcpcd wlan0" as root.I just hate to > do > > that every boot.Is there any solution ? > > I do not know if what I am proposing will help that situation, I will > only explain what I did on my laptop to get a wlan card with ndiswrapper > working. > > The first thing to do is go to YaST and network devices and select > network cards. There you select yout network card from the list (or > create a new one if it is not detected) and click on edit. In the > advanced button you can select hardware details. There you should > change the module to ndiswrapper. Also in the advanced button is > detailed settings where you should select start at boot time. Once that > is finished you push next and you should see some selection where you > can edit the ESSID and encryption key. If that is not the case, you > have to remove the configuration for the device and start again from > fresh. At the first page in the configuration you can select the type. > Change it to wireless and follow the above steps. > > -- > Guðlaugur Jóhannesson > http://www.hi.is/~gudlaugu > Phone: +354 849 8405 > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > >
