Am Montag 31 Oktober 2005 19:48 schrieb Christian Praeger <[EMAIL PROTECTED]>: > [EMAIL PROTECTED] schrieb: > >Am Montag 31 Oktober 2005 13:59 schrieb Christian Praeger > ><[EMAIL PROTECTED]>: > >>now Capi 2.0 works. But now I have another problem: > >>I want to use Capisuite to receive fax. Sometimes it works fine and > >>sometimes I don't get a fax and this error in the capisuite.log: > >>I took a look at the capisuite manual: The code 0x3400 means that > >> the ISDN protocol is ok and the transmission terminated normally. > >> But the error code 0x3311 says that the connection was not > >> successful and the remote station is not a G3 fax device?? > >is it really a G3 (analog usual) fax? Or is it G4 (ISDN unusual, > > because too expensive)? > Yes, the sender is a normal analog faxdevice.
Hi Christian, hmmm, maybe the module is broken? What modules are shown up in the output of "lsmod"? > >>On Suse 9.2 it worked with the same hardware. What's wrong in > >>Opensuse 10? > >What did you select in YaST HylaFAX or CAPI2.0 (9.3 and 10.0)? > I used in Suse 9.x the Capi interface and in 10.0 too. Did you try the HylaFAX driver? > if I send a fax from a ISDN card the fax is ok. Has the Capi 2.0 > driver any problems with G3 faxes? Maybe. I have no FAX to test it. Search bugzilla and if you do not found anything, file a bugreport. (and please, do not top-post) -- mdc --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
