Tirsdag den 5. december 2006 19:36 skrev George Stoianov: > On 12/5/06, Verner Kjærsgaard <[EMAIL PROTECTED]> wrote: > > Tirsdag den 5. december 2006 13:45 skrev Verner Kjærsgaard: > > > Hi list, > > > > > > on SuSE10.1 AND the new SuSE10.2 (rc1) I've noticed that on my IBM > > > ThinkPad R50 with an ATI Radeon RV250 Lf display (1400 x 1050), the > > > installation sets the refresh rate to 75Hz. > > > > > > This causes the driver circuit in my machine to go mad in about 30 > > > minutes from power on. The screen will gradually degrade with > > > horizontal flashing lines and eventually become completely useless. > > > > > > If I (YaST) set down the refresh rate to 60Hz the screen will stay on > > > just fine. But when moving windows around, it doesn't really look good, > > > all vertical lines are distorted with small pieces of "horizontal > > > noice" to them. > > > > > > On SUSE10 this never happened. > > > > > > Any ideas? > > > > Hi list > > > > - thank you for the answer. I actually don't know if I really have such > > an ATI card in my IBM Thinkpad R50....Don't know really how to find > > out... > > use lspci > george
To all in this thread...thanks again. This is my ThinkPad card: VGA compatible controller: ATI Technologies Inc Radeon R250 [Mobility FireGL 9000] (rev 02). Everythings works like a breeze. And the ThinkWiki is bookmarked, it's a gem! -- ------------------------------ Med venlig hilsen/Best regards Verner Kjærsgaard ------------------------------ -- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
