Hi All,
I've just put 10.2 (x86_64) on my laptop. During the installation, the
wireless network card (RT2500) was detected and configured correctly. The
network connection test passed at that point.
Subsequently, I cannot get the wi-fi to connect (no IP from DHCP, cannot ping
if I set a static address.) ifconfig reports:
wlan0 Link encap:Ethernet HWaddr 00:11:09:9B:06:2C
UP NOTRAILERS RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:3 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:1824 (1.7 Kb)
wmaster0 Link encap:UNSPEC HWaddr
00-11-09-9B-06-2C-00-00-00-00-00-00-00-00-00-00
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
and I get:
wlan0: cannot create symlink to default key
from dmesg when restarting the network.
So, what is wmaster0? Any ideas as to where to look for clues to solve this?
cheers
Dylan
--
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
