On Dec 14 2006 17:28, michael norman wrote:
>On Thursday 14 December 2006 14:19, Jan Engelhardt wrote:
>> >You can stop after make install.
>> >
>> >Then go into Yast network card config, you should see the card there,
>> > select the card and click on edit, click on advanced and hardware details
>> > and change the name to rt2500
>>
>> This is not required. Each module has a list of PCI/USB/etc. IDs it
>> supports. In fact, if I both have rt2500 and rt2500pci in /lib/modules,
>> udev happily loads both of them and I am to guess which one is in use.
>>
>I am not sure what you mean, but I can select either in
>Knetworkmanager, and in neither case will it retain the settings
>after I have entered the WEP key.
I was talking at a level below yast, where there is only modprobe, so
I might messed that up.
-`J'
--
--
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
