On Monday 02 April 2007, [EMAIL PROTECTED] wrote: > > ========= > > > > Nothing special to do Peter. Just remove the ATI driver, if > > installed, drop down to init 3, run sax2, set the 3d on, test it > > and save it. You could use "sax2 -m 0=radeon" also, if you want to > > be sure to get the radeon module loaded. > > > > I think you'll find it results in very adequate readings from > > glxgears on that card. > > Lee, > > Got it. Done as you suggested and now glxgears give me !1800 > frames/sec Enough for my needs, and saved me a few dollars > > Thanks > > Peter
========= That's not too shabby for a card that old, but it has always been one of their best. Have fun, sounds like you are getting good results and all it cost you was a few minutes of your time! regards, Lee -- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
