Rajko M. wrote:
YaST setup is trying to configure equipment so that normal user can operate
it. It can see your normal group called users and set all permissions as
appropriate, but if you are logged in as root than it will be all set that
only root can operate equipment.
OK, I tried the following steps:
1. disconnected the scanner
2. logged on with my normal user account
3. started YaST
4. gave it the root password
5. invoked the scanner configuration screen
6. deleted the entry for the scanner and clicked Finish
7. shut down YaST
8. re-connected the scanner
9. started YaST again
10. gave it the root password
11. invoked the scanner screen again
12. YaST detected the scanner
13. selected the line for the scanner
14. clicked Edit
15. confirmed that the correct driver was selected
16. clicked Next
17. clicked Finish
18. closed YaST
I still can't see the scanner as a normal user. Is this what you were
recommending I do? Did I miss a step?
--
Bob Kline
http://www.rksystems.com
mailto:[EMAIL PROTECTED]
--
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
