I downloaded the 10.3 x86_64bit dvd and was going to add a new domU on
my 10.2 system but nothing seems to work.
I have a OpenSuse 10.2 x86_64 AMD AM2 system running xen. Installing
10.2 domU works ok when done over network or iso image but I can't even
get the install to start when trying 10.3 beta 3.
Network install:
I loopback mount the .iso on a different system and export it.
I set the custom installation source url to point to it and hit next
Popup that no kernel found
Mount the same nfs on dom0 and can see /mnt/boot/x86_64/vmlinuz-xen
test the same thing with 10.2 dvd and that works.
ISO:
set iso install path to openSUSE-10.3-Beta3-DVD-x86_64.iso
after a few pop-up windows I get the same kernel error as on network
but can't cancel out of it properly, have to start "yast2 xen" all over
copying {vmlinuz,initrd]-xen from image somewhere else and use them as
a non-suse install
it starts up and I get a window where the boot up gets going but then
it hangs.
Besides the installation source everything else is left at defaults
What am I doing wrong ?(hope it's not expecting to much)
I would expect installing a 10.3 domU on a 10.2 system would be a common
thing so if it's a bug I expect it to be some noise about it.
What can I do to install a 10.3 domU ?
/ps
The end of the install that hangs shows:
PNP: No PS/2 controller found. Probing ports directly.
i8042.c: No controller found.
mice: PS/2 mouse device common for all mice
NET: Registered protocol family 1
XENBUS: Device with no driver: device/vbd/768
XENBUS: Device with no driver: device/vbd/832
XENBUS: Device with no driver: device/vif/0
Freeing unused kernel memory: 188k freed
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx/öps
SCSI subsystem initialized
st: Version 20070203, fixed bufsize 32768, s/g segs 256
BIOS EDD facility v0.16 2004-Jun-25, 0 devices found
EDD information not available.
NET: Registered protocol family 17
loop: module loaded
xen-vbd: registered block device major 3
blkfront: hda: barriers enabled
hda: unknown partition table
blkfront: hdb: barriers enabled
hdb: unknown partition table
netfront: Initialising virtual ethernet driver.
netfront: device eth0 has flipping receive path.
squashfs: version 3.2-r2 (2007/01/15) Phillip Lougher
--
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
