On Sun, 2007-09-16 at 16:39 +0800, Art Fore wrote: > When I install 10.3 Beta3, it does not recognize the raid drive setup > from the previous beta2 install, same with beta2, it did not recognize > the beta1 install on raid. I have to go through and create the raid1 > drives each time. Is there any secret to get these permanent? It does > recognize a backup raid and wants to install on it. > > Art > Well, this went from bad to worse. On initial reboot when it is installing the boot loader, it cannot find md3 which is where it just installed everything. Raid is as follows.
md0 raid1 /boot 101 MB md1 raid0 swap 1 GB md3 raid1 / 20 GB md4 raid1 /home 267 GB When booting, it comes up it cannot find /dev/md3 for initrd Has procedures changed for installing on raid or is this a bug. Art -- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
