-------------- Original message ---------------------- From: "Joe Morris (NTM)" <[EMAIL PROTECTED]> > On 10/07/2007 05:52 PM, [EMAIL PROTECTED] wrote: > > I had challenges with my RT61 based PCI card working with 10.3 out of the > box. The card was seen but despite any > > setup, my wireless didn't work. So I found a site where it showed how to > remove the rt61pci module that ships with > > 10.3 and install the CVS version from the Ralink Website. With a simple > > issue > of rcnetwork restart, it worked instantly. > > However when I rebooted, all was lost. <snip> Where is and can I remove > > the > rt61pci module or disable it so only the rt61 gets loaded. > > > Disable the rt61pci module in /etc/modprobe.d/blacklist. You should > setup the wireless via Yast2, Network Devices, Network Card and tell it > to use the rt61 module. You could also load it via > /etc/sysconfig/kernel MODULES_LOADED_ON_BOOT. HTH. > > -- > Joe Morris > Registered Linux user 231871 running openSUSE 10.2 x86_64 > > > > > > -- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] >
Thanks for someone finally answering. I got it to work by changing rt61pci.ko to rt61pci.ko.old in /lib/modules/2.6.22.5-31-default/updates. I had already set the card up under Yast2. I am not sure why rt61pci fails but rt61 (CVS) version works. Again, thanks. --Keith -- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
