Greets: Currently test/playing with 11.1 and I ran into a snag with the install process. The test system has two nics, one standard nic e100 and a D-Link Airplus G DWL-G520 which is supported(pci atheros). The current network is setup on wireless only.
The issues is that I can load all the needed drivers for the G520 but only after DHCP fails on eth0. Yast does give me the options to load either the e100 or G520 while using text mode but DHCP is already assigned at this point in the install process to eth0 and thus fails when selecting G520 Is there a way that I can load the needed modules for both the card and the wireless stack at boot time or alternatively prior to the install sequence detecting and associating DHCP with eth0. Alternatively is there a way to reassociate DHCP with the G520 once all the modules are loaded. Using yast in text mode for testing. regards and thanks for any info -- /ch -- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
