Hey All,
After building Openvas 9 from source, in a Master -> Slave scenario, I've
managed to get both nodes to communicate properly, and I've also managed to be
able to send tasks from the Master -> Slave, have the slave execute the tasks,
and then return results back to the master. This is where the problems begin.
When I look through the data on the master, the information seems incorrect,
and incomplete. I've managed to scan an entire /24, and here's some of the
errors with the results of the task:
1. The task had a task output reporting that 254 nodes were up.
Unfortunately, in this case, the entire /24 was populated with ~90 nodes.
2. The hosts that were actually up, had their OS's being reported
correctly, but their total open ports were a total of 0
3. It looks like the data is not being properly populated in the
openvasmd database:
'''
ian.abreu@[REDACTED]:~$ omp --get-report 51e4cdb2-d908-4f80-b5da-d4fe39c35ef3
--format c1645568-627a-11e3-a660-406186ea4fc5
Enter password:
IP,Hostname,Port,Port Protocol,CVSS,Severity,Solution Type,NVT
Name,Summary,Specific Result,NVT OID,CVEs,Task ID,Task Name,Timestamp,Result
ID,Impact,Solution,Affected Software/OS,Vulnerability Insight,Vulnerability
Detection Method,Product Detection Result,BIDs,CERTs,Other References
'''
Any idea where I should go from here?
Cheers,
Ian
This message has been scanned for malware by Websense. www.websense.com
_______________________________________________
Openvas-discuss mailing list
[email protected]
https://lists.wald.intevation.org/cgi-bin/mailman/listinfo/openvas-discuss
