Since I reported yesterday what is working and not working, I've been looking 
at a couple of different tutorials for openvpn dual-stack configurations. Based 
on that, I'm pretty sure the problem is in the ipv6 addressing and routing, but 
I'm not clear how to properly configure the server to get it working.

As I said, I tried using the lan prefix::/64 and fc00::/64. Using fc00, it was 
possible to ping in both directions. Using the lan prefix, the client could 
ping the server, but not vice versa. I presume this is because of the routing.

I got the ipv4 working by using this command iptables -t nat -A POSTROUTING -s 
10.8.0.0/24 -o eth0 -j MASQUERADE.

I found these two tutorials about dual-stack openvpn configurations:

OpenVPN Server and Client Installation and Configuration on Debian 7 
https://www.tecmint.com/install-openvpn-in-debian/, dated 4/4/2014

Build a OpenVPN server on Ubuntu to provide a IPv6 tunnel over IPv4 
https://techblog.synagila.com/2016/02/24/build-a-openvpn-server-on-ubuntu-to-provide-a-ipv6-tunnel-over-ipv4/,
 dated 2/24/2016

They are both quite different, presumably because of they are using different 
versions of linux and openvpn. I'm really surprised this isn't documented on 
the openvpn website.

I'm looking for a minimally simple server configuration, preferably one that's 
authoritative from the openvpn community and known to work on ubuntu 16.04 with 
openvpn 2.4. If someone can point me in the right direction, I'd appreciate it. 
I will post the configuration on the openvpn forum if I ever get it working.

Thanks.

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Openvpn-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/openvpn-users

Reply via email to