You should still be able to access the web interface on the lan side of the device. You can also enable/allow ssh on the wan interface for remote access to the AP.
On Fri, Aug 2, 2019 at 10:29 AM Даниил Никитин <[email protected]> wrote: > Hello, I'm still newbie on OpenWISP2 . I installed OpenWISP controller, > connected my device, created template: interfaces -> wireless interfacwes > and chose radio1 in radio section that was in device configuration before > OpenWISP installation. Now I only know how to set additional settings to my > device. But how can I see and change standard settings of my device, which > I didn't set using controller. > > I will be Thanksfull if anyone helps me. > best wishes, > Daniil Nikitin > > -- > You received this message because you are subscribed to the Google Groups > "OpenWISP" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To view this discussion on the web, visit > https://groups.google.com/d/msgid/openwisp/ca7bf1b7-93f7-4f3a-94c2-1ad923caa4e4%40googlegroups.com > <https://groups.google.com/d/msgid/openwisp/ca7bf1b7-93f7-4f3a-94c2-1ad923caa4e4%40googlegroups.com?utm_medium=email&utm_source=footer> > . > -- You received this message because you are subscribed to the Google Groups "OpenWISP" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web, visit https://groups.google.com/d/msgid/openwisp/CAP6YPdpvpBha0pqYU%3DdB1QowhwvPxAOpzFO8t_xfREHrtJYPJg%40mail.gmail.com.
