Hi Michele, I guess wireguard is not configured to use ipv6 link local by default, not sure if it's doable, it may be, however, it would be better to post this type of questions on Wiregard related support channels rather than here.
Federico On Fri, Apr 1, 2022 at 10:40 PM Michele Salerno <[email protected]> wrote: > Hi, > i have installed ansible-wireguard-openwisp and i have the interface on > server > wg0: flags=209<UP,POINTOPOINT,RUNNING,NOARP> mtu 1420 > inet 10.253.0.1 netmask 255.255.0.0 destination 10.253.0.1 > unspec 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00 txqueuelen > 1000 (UNSPEC) > RX packets 28 bytes 2552 (2.4 KiB) > RX errors 0 dropped 0 overruns 0 frame 0 > TX packets 18 bytes 1896 (1.8 KiB) > TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 > > on babel i have this log > Interface wg0 has no link-local address. > setsockopt(IPV6_LEAVE_GROUP): Cannot assign requested address > > i have question... > because the interface wg0 has no link-local address? > thanks. > > -- > You received this message because you are subscribed to the Google Groups > "OpenWISP" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To view this discussion on the web, visit > https://groups.google.com/d/msgid/openwisp/10d45511-b6ff-4200-9843-41074f6cbe11n%40googlegroups.com > <https://groups.google.com/d/msgid/openwisp/10d45511-b6ff-4200-9843-41074f6cbe11n%40googlegroups.com?utm_medium=email&utm_source=footer> > . > -- You received this message because you are subscribed to the Google Groups "OpenWISP" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web, visit https://groups.google.com/d/msgid/openwisp/CAAGgX6KbN-9bRqB7KOMvDE644yJFUR3dWUpQgN6NUzQ%3DLzG%3DXw%40mail.gmail.com.
