Author: jogo Date: 2015-12-02 23:16:23 +0100 (Wed, 02 Dec 2015) New Revision: 47695
Modified: trunk/target/linux/ipq806x/patches-3.18/301-ARM-qcom-add-Netgear-Nighthawk-X4-R7500-device-tree.patch trunk/target/linux/ipq806x/patches-3.18/708-ARM-dts-qcom-add-gmac-nodes-to-ipq806x-platforms.patch trunk/target/linux/ipq806x/patches-4.1/301-ARM-qcom-add-Netgear-Nighthawk-X4-R7500-device-tree.patch trunk/target/linux/ipq806x/patches-4.1/708-ARM-dts-qcom-add-gmac-nodes-to-ipq806x-platforms.patch Log: ipq806x: ap148/r7500: fix eth0 for non gige speeds Eth0 is attached to mac0 of the switch with a fixed link and and not to phy4 in single phy mode, so configuring it to anything but 1000FD will break the connection, which will happen if a only 100 Mbit capapble device is plugged into the wan port. Fix this by not taking the state from phy4 and just configuring a fixed link for eth0. Signed-off-by: Jonas Gorski <[email protected]> Modified: trunk/target/linux/ipq806x/patches-3.18/301-ARM-qcom-add-Netgear-Nighthawk-X4-R7500-device-tree.patch =================================================================== --- trunk/target/linux/ipq806x/patches-3.18/301-ARM-qcom-add-Netgear-Nighthawk-X4-R7500-device-tree.patch 2015-12-02 21:52:41 UTC (rev 47694) +++ trunk/target/linux/ipq806x/patches-3.18/301-ARM-qcom-add-Netgear-Nighthawk-X4-R7500-device-tree.patch 2015-12-02 22:16:23 UTC (rev 47695) @@ -22,7 +22,7 @@ qcom-msm8974-sony-xperia-honami.dtb --- /dev/null +++ b/arch/arm/boot/dts/qcom-ipq8064-r7500.dts -@@ -0,0 +1,338 @@ +@@ -0,0 +1,342 @@ +#include "qcom-ipq8064-v1.0.dtsi" + +#include <dt-bindings/input/input.h> @@ -257,13 +257,17 @@ + gmac1: ethernet@37200000 { + status = "ok"; + phy-mode = "rgmii"; -+ phy-handle = <&phy4>; + qcom,id = <1>; + + pinctrl-0 = <&rgmii2_pins>; + pinctrl-names = "default"; + + mtd-mac-address = <&art 6>; ++ ++ fixed-link { ++ speed = <1000>; ++ full-duplex; ++ }; + }; + + gmac2: ethernet@37400000 { Modified: trunk/target/linux/ipq806x/patches-3.18/708-ARM-dts-qcom-add-gmac-nodes-to-ipq806x-platforms.patch =================================================================== --- trunk/target/linux/ipq806x/patches-3.18/708-ARM-dts-qcom-add-gmac-nodes-to-ipq806x-platforms.patch 2015-12-02 21:52:41 UTC (rev 47694) +++ trunk/target/linux/ipq806x/patches-3.18/708-ARM-dts-qcom-add-gmac-nodes-to-ipq806x-platforms.patch 2015-12-02 22:16:23 UTC (rev 47695) @@ -29,7 +29,7 @@ }; gsbi@16300000 { -@@ -200,6 +210,27 @@ +@@ -200,6 +210,31 @@ reg = <4>; }; }; @@ -37,11 +37,15 @@ + gmac1: ethernet@37200000 { + status = "ok"; + phy-mode = "rgmii"; -+ phy-handle = <&phy4>; + qcom,id = <1>; + + pinctrl-0 = <&rgmii2_pins>; + pinctrl-names = "default"; ++ ++ fixed-link { ++ speed = <1000>; ++ full-duplex; ++ }; + }; + + gmac2: ethernet@37400000 { Modified: trunk/target/linux/ipq806x/patches-4.1/301-ARM-qcom-add-Netgear-Nighthawk-X4-R7500-device-tree.patch =================================================================== --- trunk/target/linux/ipq806x/patches-4.1/301-ARM-qcom-add-Netgear-Nighthawk-X4-R7500-device-tree.patch 2015-12-02 21:52:41 UTC (rev 47694) +++ trunk/target/linux/ipq806x/patches-4.1/301-ARM-qcom-add-Netgear-Nighthawk-X4-R7500-device-tree.patch 2015-12-02 22:16:23 UTC (rev 47695) @@ -22,7 +22,7 @@ qcom-msm8974-sony-xperia-honami.dtb --- /dev/null +++ b/arch/arm/boot/dts/qcom-ipq8064-r7500.dts -@@ -0,0 +1,338 @@ +@@ -0,0 +1,342 @@ +#include "qcom-ipq8064-v1.0.dtsi" + +#include <dt-bindings/input/input.h> @@ -257,13 +257,17 @@ + gmac1: ethernet@37200000 { + status = "ok"; + phy-mode = "rgmii"; -+ phy-handle = <&phy4>; + qcom,id = <1>; + + pinctrl-0 = <&rgmii2_pins>; + pinctrl-names = "default"; + + mtd-mac-address = <&art 6>; ++ ++ fixed-link { ++ speed = <1000>; ++ full-duplex; ++ }; + }; + + gmac2: ethernet@37400000 { Modified: trunk/target/linux/ipq806x/patches-4.1/708-ARM-dts-qcom-add-gmac-nodes-to-ipq806x-platforms.patch =================================================================== --- trunk/target/linux/ipq806x/patches-4.1/708-ARM-dts-qcom-add-gmac-nodes-to-ipq806x-platforms.patch 2015-12-02 21:52:41 UTC (rev 47694) +++ trunk/target/linux/ipq806x/patches-4.1/708-ARM-dts-qcom-add-gmac-nodes-to-ipq806x-platforms.patch 2015-12-02 22:16:23 UTC (rev 47695) @@ -29,7 +29,7 @@ }; gsbi@16300000 { -@@ -173,6 +183,27 @@ +@@ -173,6 +183,31 @@ reg = <4>; }; }; @@ -37,11 +37,15 @@ + gmac1: ethernet@37200000 { + status = "ok"; + phy-mode = "rgmii"; -+ phy-handle = <&phy4>; + qcom,id = <1>; + + pinctrl-0 = <&rgmii2_pins>; + pinctrl-names = "default"; ++ ++ fixed-link { ++ speed = <1000>; ++ full-duplex; ++ }; + }; + + gmac2: ethernet@37400000 { _______________________________________________ openwrt-commits mailing list [email protected] https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-commits
