Author: blogic Date: 2015-12-17 10:28:10 +0100 (Thu, 17 Dec 2015) New Revision: 47916
Modified: trunk/package/kernel/lantiq/ltq-atm/src/ltq_atm.c Log: lantiq: ltq-atm: set carrier status This prevents the unconditionally start of pppd since netifd will be triggered if the device goes into showtime. The same applies to lost showtime as well. In compare to the ptm driver, this changeset isn't strictly required, since the "not in showtime" message is limited to the debug loglevel. But it reduces the amount of ppp related messages significant. Signed-off-by: Mathias Kresin <[email protected]> Modified: trunk/package/kernel/lantiq/ltq-atm/src/ltq_atm.c =================================================================== --- trunk/package/kernel/lantiq/ltq-atm/src/ltq_atm.c 2015-12-17 09:28:01 UTC (rev 47915) +++ trunk/package/kernel/lantiq/ltq-atm/src/ltq_atm.c 2015-12-17 09:28:10 UTC (rev 47916) @@ -1715,7 +1715,7 @@ static int atm_showtime_enter(struct port_cell_info *port_cell, void *xdata_addr) { - int i, j; + int i, j, port_num; ASSERT(port_cell != NULL, "port_cell is NULL"); ASSERT(xdata_addr != NULL, "xdata_addr is NULL"); @@ -1738,6 +1738,9 @@ g_showtime = 1; + for ( port_num = 0; port_num < ATM_PORT_NUMBER; port_num++ ) + atm_dev_signal_change(g_atm_priv_data.port[port_num].dev, ATM_PHY_SIG_FOUND); + #if defined(CONFIG_VR9) IFX_REG_W32(0x0F, UTP_CFG); #endif @@ -1752,12 +1755,18 @@ static int atm_showtime_exit(void) { + int port_num; + if ( !g_showtime ) return -1; #if defined(CONFIG_VR9) IFX_REG_W32(0x00, UTP_CFG); #endif + + for ( port_num = 0; port_num < ATM_PORT_NUMBER; port_num++ ) + atm_dev_signal_change(g_atm_priv_data.port[port_num].dev, ATM_PHY_SIG_LOST); + g_showtime = 0; g_xdata_addr = NULL; printk("leave showtime\n"); @@ -1824,6 +1833,10 @@ g_atm_priv_data.port[port_num].dev->ci_range.vci_bits = 16; g_atm_priv_data.port[port_num].dev->link_rate = g_atm_priv_data.port[port_num].tx_max_cell_rate; g_atm_priv_data.port[port_num].dev->dev_data = (void*)port_num; + +#if defined(CONFIG_IFXMIPS_DSL_CPE_MEI) || defined(CONFIG_IFXMIPS_DSL_CPE_MEI_MODULE) + atm_dev_signal_change(g_atm_priv_data.port[port_num].dev, ATM_PHY_SIG_LOST); +#endif } } _______________________________________________ openwrt-commits mailing list [email protected] https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-commits
