Hi Felix,
Thanks for your reply. Unfortunately this did not work either. I got
another kernel panic, this time with the message "Kernel unaligned
instruction access[#1]".
Output from ksymoops below.
Many thanks,
Tim
Restarting system.
Kernel unaligned instruction access[#1]:
Cpu 0
$ 0 : 00000000 bfc80b44 bfd81b8b 000e0000
$ 4 : b1000000 ffffffff ffffffff 00000000
$ 8 : 00000000 8023fffd 803e0000 803f0000
$12 : 803e0000 2ab43370 2ab3e5b0 00405c20
$16 : 01234567 28121969 fee1dead 00000000
$20 : 00405ec0 00000001 00407954 00000000
$24 : 00000196 bfc00000
$28 : 81580000 81581e08 00000000 bfd814f4
Hi : 00016666
Lo : 75300000
epc : bfd81b8b Not tainted
Using defaults from ksymoops -t elf32-i386 -a i386
Cause : 50808010
803e1000 803e1000 0000000e 00000000 00000000 803e1000 81c17878 815861b8
815751b8 81575180 2ab4a770 81581f30 81c17878 815861b8 8004c298 8004c240
81575180 803e1000 803e1000 803e1000 803e1000 803e1000 803e1000 803e1000
803e1000 00030002 803e1000 803e1000 803e1000 803e1000 803e1000 803e1000
Call Trace:[<800a1e5c>][<8004c298>][<8004c240>][<8004a3d0>][<80043398>]
Code: 0000 0000 0000 <0000> 0000 0000 0000 0000 0000
>>$12; 803e0000 <_dma_cache_wback_inv+0/4>
>>EIP; bfd81b8b <END_OF_CODE+3f98a82b/????> <=====
Trace; 800a1e5c <handle_mm_fault+354/72c>
Trace; 8004c298 <do_page_fault+158/340>
Trace; 8004c240 <do_page_fault+100/340>
Trace; 8004a3d0 <stack_done+20/3c>
Trace; 80043398 <syscall_exit+0/38>
Code; bfd81b85 <END_OF_CODE+3f98a825/????>
00000000 <_EIP>:
On Tue, Dec 9, 2008 at 11:20 AM, Felix Fietkau <[EMAIL PROTECTED]> wrote:
>
> Tim Barker wrote:
> > Hi Felix,
> >
> > Thanks for looking into this.
> >
> > Unfortunately the change did not work for me. I updated to the latest SVN (I
> > checked arch/mips/atheros/ar5315/board.c had been updated) and recompiled
> > the kernel. When trying a reboot on the EOC-2610 I got a kernel panic
> > (Unable to handle kernel paging request at virtual address d9711b8c) and no
> > reboot. Below is the output from ksymoops, I don't know if it will help.
> Please edit
> build_dir/linux-atheros/linux-2.6.26.8/arch/mips/atheros/ar5315/board.c
> and insert the following just above the mips_reset_vec() line:
> local_irq_disable();
> Then run make target/install and test the new kernel.
>
> Thanks,
>
> - Felix
> _______________________________________________
> openwrt-devel mailing list
> [email protected]
> http://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
_______________________________________________
openwrt-devel mailing list
[email protected]
http://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
