Hello,
I am working with an Atmel at91RM9200-based board, and I am new to at91,
cannot make Target System(Atmel AT91) work.
target/linux/at91/image/dfboot and target/linux/at91/image/u-boot
confused me a lot.
Any suggestions about 9200, 9260, 9261 are welcome.
Currently the bootloaders for at91rm9200 target is broken - I am busy
working on getting this at the moment - the reason for the breakage
was updating the abi for all ARM targets from oabi to eabi, and the
fact that I have not had hardware to test on for the last few months -
I did get hardware again last week, but have not had a chance to work
on this.
You could try going back to revision 11747 in SVN - the tree for at91
was known to be good at that point in time.
Regards
Hamish
_______________________________________________
openwrt-devel mailing list
[email protected]
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
