On 2010-01-28 4:28 AM, puchu wrote:
> hi
>
> the error in dmesg ...
>
> Freeing unused kernel memory: 136k freed
> roboswitch: Probing device eth0:
> roboswitch: [/home/sysadmin/wl500/OpenWrt/build/build_dir/linux-brcm47xx/kmod-
> switch/switch-robo.c:131] SIOCGETCPHYRD failed!
> roboswitch: [/home/sysadmin/wl500/OpenWrt/build/build_dir/linux-brcm47xx/kmod-
> switch/switch-robo.c:131] SIOCGETCPHYRD failed!
> No Robo switch in managed mode found, phy_id = 0xffffffff
> roboswitch: Probing device eth1:
> roboswitch: [/home/sysadmin/wl500/OpenWrt/build/build_dir/linux-brcm47xx/kmod-
> switch/switch-robo.c:131] SIOCGETCPHYRD failed!
> roboswitch: [/home/sysadmin/wl500/OpenWrt/build/build_dir/linux-brcm47xx/kmod-
> switch/switch-robo.c:131] SIOCGETCPHYRD failed!
> No Robo switch in managed mode found, phy_id = 0xffffffff
> roboswitch: Probing device eth2: No such device
> roboswitch: Probing device eth3: No such device
> diag: Detected 'ASUS WL-500g Premium'
>
> looks like "not that bad" beacuse the device comes up ...
>
> the module is loaded in /etc/init.d/boot again....
> then
>
> roboswitch: Probing device eth0: found a 5325! It's a 5350.
>
>
> but it is that bad ... because the switch is not detected at preinit and so
> failsafe wont work ....
>
> here's the patch to fix this ...
Applied in r19365
_______________________________________________
openwrt-devel mailing list
[email protected]
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
