Enable dwc_otg driver.
Signed-off-by: Layne Edwards <[email protected]>
Index: target/linux/ramips/files/arch/mips/ralink/Kconfig
===================================================================
--- target/linux/ramips/files/arch/mips/ralink/Kconfig (revision 26476)
+++ target/linux/ramips/files/arch/mips/ralink/Kconfig (working copy)
@@ -47,6 +47,7 @@
select SYS_SUPPORTS_LITTLE_ENDIAN
select SYS_HAS_EARLY_PRINTK
select MIPS_MACHINE
+ select USB_ARCH_HAS_HCD
config RALINK_DEV_GPIO_BUTTONS
def_bool n
Index: linux/ramips/rt305x/config-2.6.37
===================================================================
--- target/linux/ramips/rt305x/config-2.6.37 (revision 26476)
+++ target/linux/ramips/rt305x/config-2.6.37 (working copy)
@@ -27,6 +27,10 @@
CONFIG_CSRC_R4K_LIB=y
CONFIG_DECOMPRESS_LZMA=y
CONFIG_DMA_NONCOHERENT=y
+CONFIG_DWC_OTG=y
+# CONFIG_DWC_OTG_DEBUG is not set
+# CONFIG_DWC_OTG_DEVICE_ONLY is not set
+CONFIG_DWC_OTG_HOST_ONLY=y
CONFIG_EARLY_PRINTK=y
# CONFIG_FSNOTIFY is not set
CONFIG_GENERIC_ATOMIC64=y
@@ -81,6 +85,7 @@
CONFIG_MTD_PHYSMAP=y
CONFIG_NEED_DMA_MAP_STATE=y
CONFIG_NEED_PER_CPU_KM=y
+CONFIG_NLS=y
CONFIG_PAGEFLAGS_EXTENDED=y
CONFIG_PERF_USE_VMALLOC=y
CONFIG_PHYLIB=y
@@ -112,8 +117,8 @@
CONFIG_SYS_SUPPORTS_32BIT_KERNEL=y
CONFIG_SYS_SUPPORTS_ARBIT_HZ=y
CONFIG_SYS_SUPPORTS_LITTLE_ENDIAN=y
+CONFIG_USB=y
# CONFIG_USB_ARCH_HAS_EHCI is not set
-# CONFIG_USB_ARCH_HAS_HCD is not set
# CONFIG_USB_ARCH_HAS_OHCI is not set
CONFIG_USB_SUPPORT=y
CONFIG_ZONE_DMA_FLAG=0
Index: target/linux/ramips/patches-2.6.37/105-usb_dwc_otg.patch
===================================================================
--- target/linux/ramips/patches-2.6.37/105-usb_dwc_otg.patch (revision 0)
+++ target/linux/ramips/patches-2.6.37/105-usb_dwc_otg.patch (revision 0)
@@ -0,0 +1,16 @@
+--- a/drivers/usb/Kconfig
++++ b/drivers/usb/Kconfig
+@@ -163,4 +163,6 @@
+
+ source "drivers/usb/otg/Kconfig"
+
++source "drivers/usb/dwc_otg/Kconfig"
++
+ endif # USB_SUPPORT
+--- a/drivers/usb/Makefile
++++ b/drivers/usb/Makefile
+@@ -45,3 +45,4 @@
+
+ obj-$(CONFIG_USB_ATM) += atm/
+ obj-$(CONFIG_USB_SPEEDTOUCH) += atm/
++obj-$(CONFIG_DWC_OTG) += dwc_otg/
_______________________________________________
openwrt-devel mailing list
[email protected]
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
