Al 15/03/12 19:38, En/na John Crispin ha escrit:
> On 15/03/12 19:33, Luca Olivetti wrote:
>> The configuration for the arv752DPW22 also uses the ar8216 but the network
>> doesn't work.
>
> ;-)
It didn't work for me, but a user on the forum says it works for him :-/
The only difference I could find in the arv752DPW22 is this piece of code:
#ifdef CONFIG_SWITCH_PORT0
*DANUBE_GPIO_P0_ALTSEL0 &= ~(1<<CONFIG_SWITCH_PIN);
*DANUBE_GPIO_P0_ALTSEL1 &= ~(1<<CONFIG_SWITCH_PIN);
*DANUBE_GPIO_P0_OD |= (1<<CONFIG_SWITCH_PIN);
*DANUBE_GPIO_P0_DIR |= (1<<CONFIG_SWITCH_PIN);
*DANUBE_GPIO_P0_OUT |= (1<<CONFIG_SWITCH_PIN);
#elif defined(CONFIG_SWITCH_PORT1)
*DANUBE_GPIO_P1_ALTSEL0 &= ~(1<<CONFIG_SWITCH_PIN);
*DANUBE_GPIO_P1_ALTSEL1 &= ~(1<<CONFIG_SWITCH_PIN);
*DANUBE_GPIO_P1_OD |= (1<<CONFIG_SWITCH_PIN);
*DANUBE_GPIO_P1_DIR |= (1<<CONFIG_SWITCH_PIN);
*DANUBE_GPIO_P1_OUT |= (1<<CONFIG_SWITCH_PIN);
#endif
(since arv752DPW22 defines CONFIG_SWITCH_PORT1).
I don't know if that's what's causing problems with the network, anyway having
a prompt corresponding to the board is neater ;-)
Bye
--
Luca
_______________________________________________
openwrt-devel mailing list
[email protected]
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
