-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hi,

first, dont worry its *not* about asking how to unbrick ;) This is
well documented in the wiki and working fine with serial and tftp..

I rather want to understand, what went wrong (or if it's maybe a
problem that others might run into and avoid it even if its only by
telling about..)


What I did:
- - full buildoot checked out from trunk, long and last working fine
with r31676.
The inital checkout was under Ubuntu 10.04 or 10.10, now running
12.04/32bit (if that matters)
Didnt change anything (significant) anywhere under target or such,
only some small adjustments in feeds/packages and an own feed only
providing userland-stuff..
- - did "svn up" today, only in trunk, not packages (if it matters) ->
r31845
- - make menuconfig, nothing changed besides "Release version number"
and remove some <M>-packages
- - make -j 8, the i7 worked for some hours, all looked fine
- - flashed
openwrt-ar71xx-generic-tl-wr1043nd-v1-squashfs-sysupgrade.bin like
many times before through LuCI

and then:
- --- cut ---
U-Boot 1.1.4 (Nov 17 2009 - 11:56:26)

AP83 (ar9100) U-boot 0.0.11
DRAM:
sri
32 MB
id read 0x100000ff
flash size 8MB, sector count = 128
Flash:  8 MB
Using default environment

In:    serial
Out:   serial
Err:   serial
Net:   ag7100_enet_initialize...
No valid address in Flash. Using fixed address
: cfg1 0xf cfg2 0x7114
eth0: 00:03:7f:09:0b:ad
eth0 up
eth0
Autobooting in 1 seconds## Booting image at bf020000 ...
   Uncompressing Kernel Image ... OK

Starting kernel ...



OpenWrt kernel loader for AR7XXX/AR9XXX
Copyright (C) 2011 Gabor Juhos <[email protected]>
Looking for OpenWrt image... found at 0xbf022000
Decompressing kernel... done!
Starting kernel at 80060000...

[    0.000000] Linux version 3.3.7 (markstaller@v3750mm) (gcc version
4.6.3 20120201 (prerelease) (Linaro GCC 4.6-2012.02) ) #1 Thu May 24
19:33:25 CEST 2012
[    0.000000] bootconsole [early0] enabled
[    0.000000] CPU revision is: 00019374 (MIPS 24Kc)
[    0.000000] SoC: Atheros AR9132 rev 2
[    0.000000] Clocks: CPU:400.000MHz, DDR:400.000MHz, AHB:200.000MHz,
Ref:5.000MHz
[    0.000000] Determined physical RAM map:
[    0.000000]  memory: 02000000 @ 00000000 (usable)
[    0.000000] Initrd not found or empty - disabling initrd
[    0.000000] Zone PFN ranges:
[    0.000000]   Normal   0x00000000 -> 0x00002000
[    0.000000] Movable zone start PFN for each node
[    0.000000] Early memory PFN ranges
[    0.000000]     0: 0x00000000 -> 0x00002000
[    0.000000] Built 1 zonelists in Zone order, mobility grouping on.
 Total pages: 8128
[    0.000000] Kernel command line:  board=TL-WR1043ND
console=ttyS0,115200 rootfstype=squashfs,jffs2 noinitrd
[    0.000000] PID hash table entries: 128 (order: -3, 512 bytes)
[    0.000000] Dentry cache hash table entries: 4096 (order: 2, 16384
bytes)
[    0.000000] Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
[    0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize
32 bytes.
[    0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases,
linesize 32 bytes
[    0.000000] Writing ErrCtl register=00000000
[    0.000000] Readback ErrCtl register=00000000
[    0.000000] Memory: 29304k/32768k available (2122k kernel code,
3464k reserved, 366k data, 168k init, 0k highmem)
[    0.000000] SLUB: Genslabs=9, HWalign=32, Order=0-3, MinObjects=0,
CPUs=1, Nodes=1
[    0.000000] NR_IRQS:48
[    0.000000] Calibrating delay loop... 265.42 BogoMIPS (lpj=1327104)
[    0.080000] pid_max: default: 32768 minimum: 301
[    0.080000] Mount-cache hash table entries: 512
[    0.090000] NET: Registered protocol family 16
[    0.090000] gpiochip_add: registered GPIOs 0 to 21 on device: ath79
[    0.100000] MIPS: machine is Generic AR71XX/AR724X/AR913X based board
[    0.110000] bio: create slab <bio-0> at 0
[    0.110000] Switching to clocksource MIPS
[    0.120000] NET: Registered protocol family 2
[    0.120000] IP route cache hash table entries: 1024 (order: 0, 4096
bytes)
[    0.130000] TCP established hash table entries: 1024 (order: 1,
8192 bytes)
[    0.140000] TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
[    0.140000] TCP: Hash tables configured (established 1024 bind 1024)
[    0.150000] TCP reno registered
[    0.150000] UDP hash table entries: 256 (order: 0, 4096 bytes)
[    0.160000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
[    0.160000] NET: Registered protocol family 1
[    0.190000] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[    0.190000] JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME)
(CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc.
[    0.200000] msgmni has been set to 57
[    0.210000] io scheduler noop registered
[    0.210000] io scheduler deadline registered (default)
[    0.220000] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
[    0.240000] serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a
16550A
[    0.250000] console [ttyS0] enabled, bootconsole disabled
[    0.250000] console [ttyS0] enabled, bootconsole disabled
[    0.270000] TCP westwood registered
[    0.270000] NET: Registered protocol family 17
[    0.280000] Bridge firewalling registered
[    0.280000] 8021q: 802.1Q VLAN Support v1.8
[    0.290000] VFS: Cannot open root device "(null)" or unknown-block(0,0)
[    0.290000] Please append a correct "root=" boot option; here are
the available partitions:
[    0.300000] Kernel panic - not syncing: VFS: Unable to mount root
fs on unknown-block(0,0)

- --- cut ---

Whats missing compared to my last image:
- --- cut ---
...
[    0.490000] console [ttyS0] enabled, bootconsole disabled
[    0.500000] Atheros AR71xx SPI Controller driver version 0.2.4
[    0.510000] m25p80 spi0.0: found s25sl064a, expected m25p80
[    0.510000] m25p80 spi0.0: s25sl064a (8192 Kbytes)
[    0.520000] 5 tp-link partitions found on MTD device spi0.0
[    0.520000] Creating 5 MTD partitions on "spi0.0":
...
- --- cut ---


- -> If its just my buildroot trashed, well, i'll check out fresh and
rebuild but if it's worth any further investigation let me know..

I'd also just want to understand why this happened and whats exactly
missing to avoid it in future.. Not 110% sure, but 99% I didnt fiddle
anywhere besides userland feeds/packages or smthg..

tia,

Michael
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.11 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org/

iEYEARECAAYFAk++sUcACgkQaWRHV2kMuAL/nwCfTm645r+BWs0RKPBydxfOih06
EcoAoJT7HDbOOSzkeM09ZVpEJtzR9fi6
=ZVtO
-----END PGP SIGNATURE-----
_______________________________________________
openwrt-devel mailing list
[email protected]
https://lists.openwrt.org/mailman/listinfo/openwrt-devel

Reply via email to