Hi all, I have an ADB P.DGA4001N with board id: 963281TAN.
I flashed http://downloads.openwrt.org/attitude_adjustment/12.09-rc1/brcm63xx/generic/openwrt-963281TAN-8M-flash-generic-squashfs-cfe.bin with success, but the router has no wifi: root@OpenWrt:/# uci show wireless wireless.radio0=wifi-device wireless.radio0.type=mac80211 wireless.radio0.channel=11 wireless.radio0.macaddr=00:00:00:00:00:00 wireless.radio0.hwmode=11g wireless.radio0.disabled=0 wireless.@wifi-iface[0]=wifi-iface wireless.@wifi-iface[0].device=radio0 wireless.@wifi-iface[0].network=lan wireless.@wifi-iface[0].mode=ap wireless.@wifi-iface[0].ssid=OpenWrt wireless.@wifi-iface[0].encryption=none root@OpenWrt:/# wifi Configuration file: /var/run/hostapd-phy0.conf Could not set interface wlan0 flags (UP): Cannot assign requested address nl80211: Could not set interface 'wlan0' UP nl80211: Failed to add interface wlan0 into bridge br-lan: Invalid argument nl80211 driver initialization failed. Failed to start hostapd for phy0 root@OpenWrt:/# cat /sys/class/ieee80211/phy0/macaddress 00:00:00:00:00:00 dmesg shows this: [ 12.648000] PCI: Enabling device 0000:01:00.0 (0000 -> 0002) [ 12.656000] bcma: bus0: Found chip with id 0xA8D9, rev 0x01 and package 0x0A [ 12.664000] bcma: bus0: Core 0 found: ChipCommon (manuf 0x4BF, id 0x800, rev 0x22, class 0x0) [ 12.672000] bcma: bus0: Core 1 found: IEEE 802.11 (manuf 0x4BF, id 0x812, rev 0x17, class 0x0) [ 12.680000] bcma: bus0: Core 2 found: PCIe (manuf 0x4BF, id 0x820, rev 0x0F, class 0x0) [ 12.764000] bcma: bus0: Failed to get SPROM: -71 [ 12.768000] bcma: bus0: Bus registered [ 13.064000] b43-phy0: Broadcom 43225 WLAN found (core revision 23) [ 13.072000] b43-phy0: Found PHY: Analog 8, Type 4 (N), Revision 6 [ 13.076000] Broadcom 43xx driver loaded [ Features: PNL ] Any ideas? Regards. Ernesto. _______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/mailman/listinfo/openwrt-devel
