I would like to thank blogic for his help in progressing this issue. I did a
post to the forum last night, link is at bottom of this post, a RAMDISK image
boots fine and almost everything appears to work fine but...... NAND is
recognised but uImage cannot be found, the NOR probe fails
A couple of questions:
How is it possible to explicitly set the clock speed of the FPI bus in a device
tree file? The BTHH2B has a CPU speed of 333MHz, DRAM runs at 166MHz and the
FPI *should* operate at 83MHz.
How do I specify in the devicetree to use the JEDEC probe for NOR?
The 'flinfo' command in u-boot reports:
Bank # 1: AMD/Spansion S29AL004D (4Mbit, B)
Size: 0 MB in 11 Sectors
Sector Start Addresses:
B0000000 B0004000 B0006000 B0008000 B0010000
B0020000 B0030000 B0040000 B0050000 B0060000
B0070000
nand info reports:
Device 0: NAND 32MiB 3,3V 8-bit, sector size 16 KiB
bdinfo reports:
boot_params = 0x83B8FFB0
memstart = 0x80000000
memsize = 0x04000000
flashstart = 0xB0000000
flashsize = 0x00080000
flashoffset = 0x0002E008
ethaddr = 98:8B:5D:BD:3C:40
ip_addr = 192.168.1.11
baudrate = 115200 bps
https://forum.openwrt.org/viewtopic.php?id=41989
_______________________________________________
openwrt-devel mailing list
[email protected]
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
