Failsafe listens on eth0 by default, but due to the order of eth registration eth0 previously corresponded to the port labelled as WAN. This may cause some inconvenience since people have to plug the cable out from LAN into WAN when accessing failsafe mode and then plug back when recovery is done.
Signed-off-by: Yousong Zhou <[email protected]> --- A previous version of this patch [1] has been sent but was not receiving any response and now can not be applied without conflict. [1] http://patchwork.openwrt.org/patch/3765/ .../ar71xx/base-files/etc/uci-defaults/02_network | 1 - .../files/arch/mips/ath79/mach-tl-wr720n-v3.c | 2 +- 2 files changed, 1 insertions(+), 2 deletions(-) diff --git a/target/linux/ar71xx/base-files/etc/uci-defaults/02_network b/target/linux/ar71xx/base-files/etc/uci-defaults/02_network index 176c485..482ad6b 100755 --- a/target/linux/ar71xx/base-files/etc/uci-defaults/02_network +++ b/target/linux/ar71xx/base-files/etc/uci-defaults/02_network @@ -234,7 +234,6 @@ pb42 |\ pb44 |\ routerstation|\ tl-wr710n |\ -tl-wr720n-v3|\ wpe72) ucidef_set_interfaces_lan_wan "eth1" "eth0" ;; diff --git a/target/linux/ar71xx/files/arch/mips/ath79/mach-tl-wr720n-v3.c b/target/linux/ar71xx/files/arch/mips/ath79/mach-tl-wr720n-v3.c index 80e8df6..71d18d2 100644 --- a/target/linux/ar71xx/files/arch/mips/ath79/mach-tl-wr720n-v3.c +++ b/target/linux/ar71xx/files/arch/mips/ath79/mach-tl-wr720n-v3.c @@ -98,8 +98,8 @@ static void __init tl_wr720n_v3_setup(void) ath79_init_mac(ath79_eth1_data.mac_addr, mac, 2); ath79_register_mdio(0, 0x0); - ath79_register_eth(0); ath79_register_eth(1); + ath79_register_eth(0); ath79_register_wmac(ee, mac); } -- 1.7.2.5 _______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
