thomson usually sticks with crappy broadcom so don't give much hope for AR9271..
On 17 October 2013 09:33, Jacek Kikiewicz <[email protected]> wrote: > Hi, > > First start with gainig console access... > > Then you need to check what boot loader is there. > Depending on what it is your next steps will vary, let's hope it's > supported one :) > > > On 17.10.2013 11:16, Marco Antonio Mauro wrote: > >> Hi everyone, >> >> I have a Thomson TG585v8 Amazon-SE device. >> >> The device seems almost identical to the Netgear DGN1000B already in >> openwrt, and I'd like to add support for the specific board. But can't >> seem to figure out how to do it. I previously added support for a >> ralink device but the process seems different here. >> >> The board has: >> >> - Lantiq PSB50601HL v1.2 Processor, supposedly clocked at 266MHz >> - Winbond W25Q64BV SPI flash, 8MBytes >> - Winbond W9825G6H SDRAM, 32MBytes total >> - Broadcom BCM5325E switch >> - USB2 wifi card for AP, can't remove the EMI shield to confirm model >> but probably Atheros AR9271 >> - a couple buttons and leds. >> >> Can anyone give me some pointers on what to do? >> >> Thank you! >> >> PS: I'll add the device with the photos of the board to the wiki later >> >> ______________________________**_________________ > openwrt-devel mailing list > [email protected].**org <[email protected]> > https://lists.openwrt.org/cgi-**bin/mailman/listinfo/openwrt-**devel<https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel> >
_______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
