ok, no idea why it is not in trunk but marked as accepted but i would assume its my fault
thanks, merged in r41653 On 14/07/2014 18:55, Claudio Leite wrote: > Hello, > > * Claudio Leite (lei...@staticky.com) wrote: >> Use pr_debug rather than pr_info since it is only relevant for >> debugging. >> >> Signed-off-by: Claudio Leite <lei...@staticky.com> > > While we are talking about things for Barrier Breaker RC's, could > this patch be merged in? It was marked as accepted back in April, > but I just tested the RC1 release on a RT2880 board and it still > has the mdio r/w dumps. > > While it doesn't affect actual performance, it does slow down boot > by a few seconds while it programs the switch. > >> --- .../0220-NET-ralink-squelch_mdio_access.patch | 22 >> ++++++++++++++++++++++ 1 file changed, 22 insertions(+) create >> mode 100644 >> target/linux/ramips/patches-3.10/0220-NET-ralink-squelch_mdio_access.patch >> >> >> >> diff --git a/target/linux/ramips/patches-3.10/0220-NET-ralink-squelch_mdio_access.patch b/target/linux/ramips/patches-3.10/0220-NET-ralink-squelch_mdio_access.patch >> new file mode 100644 index 0000000..bc92a02 --- /dev/null +++ >> b/target/linux/ramips/patches-3.10/0220-NET-ralink-squelch_mdio_access.patch >> >> >> @@ -0,0 +1,22 @@ >> +Index: linux-3.10.34/drivers/net/ethernet/ralink/mdio_rt2880.c >> +=================================================================== >> >> >> +--- linux-3.10.34.orig/drivers/net/ethernet/ralink/mdio_rt2880.c >> ++++ linux-3.10.34/drivers/net/ethernet/ralink/mdio_rt2880.c +@@ >> -136,7 +136,7 @@ int rt2880_mdio_read(struct mii_bus *bus + if >> (err) + return 0xffff; + +- pr_info("%s: addr=%04x, >> reg=%04x, >> value=%04x\n", __func__, ++ pr_debug("%s: addr=%04x, reg=%04x, >> value=%04x\n", __func__, + phy_addr, phy_reg, >> fe_r32(FE_MDIO_ACCESS) & 0xffff); + + return >> fe_r32(FE_MDIO_ACCESS) & 0xffff; +@@ -148,7 +148,7 @@ int >> rt2880_mdio_write(struct mii_bus *bu + int err; + u32 t; + +- >> pr_info("%s: addr=%04x, reg=%04x, value=%04x\n", __func__, ++ >> pr_debug("%s: addr=%04x, reg=%04x, value=%04x\n", __func__, + >> phy_addr, phy_reg, fe_r32(FE_MDIO_ACCESS) & 0xffff); + + err = >> rt2880_mdio_wait_ready(priv); -- 1.8.2.1 > > Thanks. -Claudio _______________________________________________ > openwrt-devel mailing list openwrt-devel@lists.openwrt.org > https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel > _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel