Hi maintainers, As requested I'm trying to send my patch to the mail list.
Whith these patch I'm able to: 1. get rt2800pci driver to probe the wifi board. 2. leds connected to stp to work again (some changes into openwrt broken them) 3. gphy leds working Regards Eddi De Pieri (10): lantiq: fix some alt function on pinctrl-xway lantiq - vgv7519: fix gphy led configuration (this set correct alt function to gpio and let peripherials on pci bus to comes up) lantiq - vgv7519: we don't have dual minipci-card so we don't need gnt1-req1 for pci handling lantiq - vgv7519: we don't have pcie bus so we don't need the reset device tree for this board lantiq - vgv7519: remove exin definition copied from dev-board dts lantiq - vgv7519: add pci-rst entry into dts lantiq - vgv7519: fix open-drain configuration for stp lantiq - vgv7519: remove spi_cs4, since the board use this line for something else lantiq - vgv7519: enable pci bus lantiq - vgv7519: load rt5362 eeprom from bootloader param patition .../etc/hotplug.d/firmware/10-rt2x00-eeprom | 2 +- target/linux/lantiq/dts/VGV7519.dtsi | 48 +++++++++++--------- target/linux/lantiq/dts/VGV7519BRN.dts | 6 +++ target/linux/lantiq/dts/VGV7519NOR.dts | 6 +++ .../patches-3.14/0150-lantiq-pinctrl-xway.patch | 15 ++++++ target/linux/lantiq/xrx200/config-3.14 | 2 +- 6 files changed, 55 insertions(+), 24 deletions(-) create mode 100644 target/linux/lantiq/patches-3.14/0150-lantiq-pinctrl-xway.patch -- 1.7.10.4 _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel