On 2014-12-05 17:15, David Hutchison wrote: > Hello, > > Yes the problem remains when enable_vlan is set to 0 > > I don't think it's related to your changes either. I synced with trunk > in hope that your changes made a difference with my problem. However > that does not seem to be the case. > > I was hoping someone could point me in the right direction. Does this > sound more like an issue with ag71xx since that is what exposes the > "eth0" interface? Could it be as simple as the switch just isn't > recognized? Perhaps the switch interconnect is no longer RGMII and > should be GMII? > > If I knew where in those drivers to start looking, I could probably > help fix this problem. I enjoy tinkering with the drivers, and > learning how to fix them :) > > I was hoping you had some knowledge about how the interface becomes > tied with the switch itself, and if there were any specifics for the > ar8327 that must be set before the communication between the CPU + > Switch Chip can happen. > > Felix, would you by chance have any ideas as to what to check next? > The switch0 interface works fine, the eth0 interface tied to the > switch. Does not. > > The other thing to note ( and i'm not sure if this is by design ).. I > used to be able to do "swconfig dev eth0 show" and show the switch the > eth0 was connected to. Now I must use "swconfig dev switch0 show" to > configure the switch. When you do "swconfig dev eth0 show" it says it > Failed to connect to the switch. In the past, I have always used eth0 > to configure the switch however that may have been incorrect. Please post your network/switch configuration, and the output of swconfig dev switch0 show
- Felix _______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
