Hi again, Thanks for rapid answer.
By default, my board id is "F@ST2804V7". With this id, i cannot use openWrt. My CFE bootloader allows to change it, so i changed it to "F@ST2704V2". This change allowed openWrt to launch. My question is "How to add openWrt support for F@ST2804V7 ? Where should I request this ?" BRGDS, Eugene. 17.12.2014 00:11, José Vázquez пишет: > Take a look at this patch: > http://patchwork.openwrt.org/patch/6751/ > First of all you need to find your router's board id. > > If changing the board id CFE works then you have a some kind of solution. > > 2014-12-16 9:26 GMT+01:00, Eugene <[email protected]>: >> Hello, >> >> Is it possible to add support for Sagemcom F@ST2804V7 ? >> >> I tried [email protected] and some others >> (barrier_breaker) on it, >> bootlog (via serial port) says: Kernel panic - not syncing: unable to >> detect bcm963xx board. >> >> If it is possible, i will supply all required information/data. >> >> P.S. Openwrt works if I change board ID in CFE to F@ST2704V2(with 'b' >> command) >> >> Best regards, >> Eugene >> _______________________________________________ >> openwrt-devel mailing list >> [email protected] >> https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel >> _______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
