Portmap?This value is only for the default VLAN config of the switch right? But the problem I'm facing is that the link status of port 5 is always "link down" even if I plugged in the network cable:-(
2015-02-19 15:24 GMT+08:00 Mikko Hissa <[email protected]>: > Hi! > > On 19 Feb 2015, at 04:14, 郭传鈜 <[email protected]> wrote: > > Hello,everyone! > There is a kind of Huawei HG255D which has an RTL8211CL Gigabit PHY and We > are trying to add support for it. > But I can't find anything about the RGMII and mdio-bus in any dts file of > rt305x-based devices:-( > The only device I found which used the interface is WL-351 with an RTL8366 > switch but it doesn't use the MDIO interface to control it. I tried to > copy the fpa2 and fct2 value from WL-351.dts but ,of course, it doesn't > work. > Then I tried to do the following: > > https://github.com/981213/openwrt/commit/47fa84df4dcc9b8bfe49ed2211d463ed014e2df2 > > > Yes, there's that and then you need to configure registers for gdma2 in > the ethernet driver... Register a second netdev and map packets, to the > corresponding netdev/gdma (in/out) interface, by dma descriptors. > > OR > > In the dst file under the esw, change the value of portmap to 3f. > XD > > > but it doesn't work too. > Could someone please tell me what should I do in the dts file and how can > I reset the PHY? > > > Sorry for my bad English:-) > > _______________________________________________ > openwrt-devel mailing list > [email protected] > https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel > > >
_______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
