On 15/05/15 10:48, Jakub Jančo wrote:
Hello, After I unplug cable:ifconfig eth0 Link encap:Ethernet HWaddr 14:CC:20:4D:3D:B5 inet addr:10.1.5.246 Bcast:10.1.5.255 Mask:255.255.255.0 inet6 addr: fe80::16cc:20ff:fe4d:3db5/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:747 errors:0 dropped:0 overruns:0 frame:0 TX packets:896 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:84708 (82.7 KiB) TX bytes:487679 (476.2 KiB) Interrupt:4 ip link 2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UP mode DEFAULT group default qlen 1000 link/ether 14:cc:20:4d:3d:b5 brd ff:ff:ff:ff:ff:ff After plug in cable, no change, no logs. ModelTP-Link TL-WR1043N/ND v2 Firmware Version OpenWrt Barrier Breaker 14.07 / LuCI Trunk (svn-r10472) Kernel Version3.10.49
Do you have the switch configured correctly? You can use swconfig to check the physical port status.
http://wiki.openwrt.org/toh/tp-link/tl-wr1043nd _______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
