Hi list! On an EnGenius ESR1750 running current trunk (r46386), the ath10k driver fails to load the firmware blob - it did work in Barrier Breaker though. Here's the failing dmesg bits:
---snip--- [ 72.050000] PCI: Enabling device 0000:00:00.0 (0000 -> 0002) [ 72.060000] ath10k_pci 0000:00:00.0: pci irq legacy interrupts 0 irq_mode 0 reset_mode 0 [ 72.280000] ath10k_pci 0000:00:00.0: Direct firmware load for ath10k/cal-pci-0000:00:00.0.bin failed with error -2 [ 72.290000] ath10k_pci 0000:00:00.0: Falling back to user helper [ 72.360000] firmware ath10k!cal-pci-0000:00:00.0.bin: firmware_loading_store: map pages failed [ 72.460000] ath10k_pci 0000:00:00.0: otp calibration failed: 2 [ 72.470000] ath10k_pci 0000:00:00.0: failed to run otp: -22 [ 72.470000] ath10k_pci 0000:00:00.0: could not init core (-22) [ 72.480000] ath10k_pci 0000:00:00.0: could not probe fw (-22) ---snap--- Barrier Breaker dmesg instead: ---snip--- [ 12.440000] ath10k_pci 0000:00:00.0: BAR 0: assigned [mem 0x10000000-0x101fffff 64bit] [ 12.450000] PCI: Enabling device 0000:00:00.0 (0000 -> 0002) [ 12.750000] ath10k: pci irq legacy irq_mode 0 reset_mode 0 [ 13.160000] ath10k: otp stream is empty, using board.bin contents [ 14.120000] ath10k: qca988x hw2.0 (0x4100016c, 0x043202ff) fw 10.1.467.3-1 api 2 htt 2.1 ---snap--- Any hints on this? Thanks, -- Christian Beier, CTO. W shoutrlabs.com E [email protected] L https://www.linkedin.com/in/christianbeier P +49 (0)30 12076581 T https://twitter.com/shoutrlabs what is, is; what is not is possible. shoutr labs UG (haftungsbeschränkt), Wolfener Straße 32-34, Haus K, CleanTech Innovation Center, 12681 Berlin HRB 154532 B, AG Charlottenburg Managing directors: Christian Beier, Benjamin Werner, Sebastian Winkler _______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
