Sorry there was a typo in my last e-mail.
It should have been:
config interface lan6
option proto dhcpv6
option ifname @lan
After doing the change, please run: reload_config
Cheers,
Steven
Am 24.07.2015 um 14:27 schrieb Pratik Prajapati:
> I have added that section on target's /etc/config/network file
>
> but still ipv6 is not assigned to it
>
> ifconfig on target:
>
> eth0 Link encap:Ethernet HWaddr E2:AB:C0:A8:5F:38
> inet6 addr: fe80::e0ab:c0ff:fea8:5f38/64 Scope:Link
> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> RX packets:8730 errors:0 dropped:0 overruns:0 frame:0
> TX packets:191 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:1000
> RX bytes:968468 (945.7 KiB) TX bytes:17574 (17.1 KiB)
> Interrupt:57
>
> lo Link encap:Local Loopback
> inet addr:127.0.0.1 Mask:255.0.0.0
> inet6 addr: ::1/128 Scope:Host
> UP LOOPBACK RUNNING MTU:65536 Metric:1
> RX packets:8225 errors:0 dropped:0 overruns:0 frame:0
> TX packets:8225 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:0
> RX bytes:677074 (661.2 KiB) TX bytes:677074 (661.2 KiB)
>
> On Fri, Jul 24, 2015 at 5:32 PM, Steven Barth <[email protected]
> <mailto:[email protected]>> wrote:
>
> Add a section like this:
>
> config lan6
> option proto dhcpv6
> option ifname @lan
>
>
> And yes, proto dhcpv6 also works with RAs only.
> _______________________________________________
> openwrt-devel mailing list
> [email protected] <mailto:[email protected]>
> https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
>
>
_______________________________________________
openwrt-devel mailing list
[email protected]
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
