On 2018-07-29 22:16, Hans Dedecker wrote:
On Fri, Jul 27, 2018 at 2:36 PM Torbjorn Jansson
<[email protected]> wrote:
Hello
i decided to try to upgrade my erx-sfp from an old snapshot (probably a year or
so old) to 18.06-rc2.
for the most part it worked out but there is something odd going on with my 6rd
wan interface and i'm not sure where to start the troubleshooting.
with luci-proto-ipv6 and 6rd packages installed i get a lot of stuff like this
in syslog:
14:29:07 2018 daemon.notice netifd: wan6 (24771): Command failed: Unknown error
14:29:07 2018 daemon.notice netifd: Interface 'wan6' is now down
14:29:07 2018 daemon.notice netifd: Interface 'wan6' is setting up now
14:29:08 2018 daemon.notice netifd: wan6 (24856): Command failed: Unknown error
14:29:08 2018 daemon.notice netifd: Interface 'wan6' is now down
14:29:08 2018 daemon.notice netifd: Interface 'wan6' is setting up
(dates removed to make log easier to fit in mail without line breaks)
this repeats every second and 6rd interface seems to get ip adress but it is
not quite working.
plus i noticed under Network -> Interfaces in webinterface i now have two
similar looking 6rd interfaces.
one named WAN6 and thats the one i created and another one that cant be edited
that's called WAN_6
WAN6 is listed as protocol: IPv6-over-IPv4 (6rd)
WAN_6 is listed as protocol: Virtual dynamic interface (IPv6-over-IPv4 (6rd))
the last interface must be something new or a problem or something.
it is also that interface that gets the ipv6 addresses.
any idea whats wrong?
or how to find out what command failed in the log?
Hi,
You cannot enable both an automatic 6rd interface (wan_6) and a manual
created 6rd interface (wan6); Either remove the manual created 6rd
interface or set iface6rd to 0 in the wan network config which will
disable the automatic creation of the 6rd wan_6 interface
Hans
i'm not sure i get it.
where is the auto created 6rd interface that can't be edited coming from if not
from the one i created myself?
the errors stopped once i changed "bring up on boot" on wan6 and ipv6 still
works (after reboot) but i don't understand why.
the config i'm running with is exactly the same as i had on old version of
openwrt/lede and it worked just fine.
i guess something is different now.
if i delete wan6 then i delete all 6rd settings like remote ipv4 address, the
ipv6 prefix and so on.
_______________________________________________
openwrt-devel mailing list
[email protected]
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
