I have BT Home Hub 5 routers.
I have just built release 9290.
Something happened to the broadband LED configuration between release
8495 and 9290
In 9290 LED associated to device pppoa-wan no longer works (it remains
off once the pppoa-wan connection is established), however if, after
having established the pppoa-wan communication, I apply the exact same
configuration (through luci), the LED starts working normally until the
line state changes again.
Here is my LED configuration for the broadband LED:
config led 'led_internet'
option name 'internet'
option sysfs 'bthomehubv5a:blue:broadband'
option trigger 'netdev'
option mode 'link tx rx'
option default '0'
option dev 'pppoa-wan'
config led 'led_dsl'
option name 'dsl'
option trigger 'netdev'
option sysfs 'bthomehubv5a:red:broadband'
option default '0'
option dev 'dsl0'
option mode 'link'
The normal expected behaviour is: the broadband LED blinks RED whilst
the DSL link is negoatiated.
Once the DSL link is established and pppoa-wan starts, the LED turns
BLUE and it blinks during packet exchanges.
led_dsl controls the red flashing whilst the dsl connection is negotiated
led_internet turns the led blue and blinking when the pppoa-wan
connection is established.
Has something changed in the firmware that requires a configuration
change, or is this a bug?
_______________________________________________
openwrt-devel mailing list
[email protected]
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
