пн, 23 сент. 2019 г. в 16:34, Adrian Schmutzler <[email protected]>: > > If already included in ucidef_add_switch, you do not have to > additionally set the interface mode in ucidef_set_interfaces_* > functions. > > This patch removes/adjusts such redundant cases. > > Signed-off-by: Adrian Schmutzler <[email protected]> > > --- > > This is not tested on the affected devices. > > However, the same approach is taken for other targets, and > network setup is essentially device-independent concerning the > changes done here. > --- > target/linux/ipq40xx/base-files/etc/board.d/02_network | 7 +++---- > 1 file changed, 3 insertions(+), 4 deletions(-) > > diff --git a/target/linux/ipq40xx/base-files/etc/board.d/02_network > b/target/linux/ipq40xx/base-files/etc/board.d/02_network > index e5ba7260f3..b7631a301c 100755 > --- a/target/linux/ipq40xx/base-files/etc/board.d/02_network > +++ b/target/linux/ipq40xx/base-files/etc/board.d/02_network > @@ -24,14 +24,14 @@ ipq40xx_setup_interfaces() > ;; > asus,rt-ac58u|\ > zyxel,nbg6617) > - ucidef_set_interfaces_lan_wan "eth0" "eth1" > + ucidef_set_interface_wan "eth1" > ucidef_add_switch "switch0" \ > "0u@eth0" "1:lan:4" "2:lan:3" "3:lan:2" "4:lan:1" > ;;
I planned to investigate this, but didn't find time yet. The config initially is wrong. For asus,rt-ac58u|\ > zyxel,nbg6617) There should be port 5 on vid 2 for eth 1 to enable vlan working. Currently saving any config in luci breaks vlans, because port 5 isn't defined here. The port 5 is removed. I suggest lo leave this alone for a while. I am going to find some kind of a solultion and suggest it. _______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/mailman/listinfo/openwrt-devel
