12/11/2019 13:26, Adrian Schmutzler:
Hi,
I'm currently trying to remove the dependency of label_mac in 02_network from
phy setup, i.e. replacing stuff like
$(cat /sys/class/ieee80211/phyX/macaddress)
with extraction from the proper flash location.
One obstacle is the AVM FRITZ!WLAN Repeater 300E, where the calibration data is
extracted with
caldata_extract_reverse "urloader" 0x1541 0x440
Is there a sufficiently easy way to get the MAC address out of there _without_
relying on initialized Wifi?
I'm looking for something like
label_mac=$(some_extraction_function "urloader" <some_offset>)
Technically, it should be somewhere in the reversed caldata, shouldn't it?
If this is not possible (with reasonable effort), I would just calculate it
based on the lan_mac in 02_network.
Best
Adrian
Hey Adrian,
all mac-addresses can be found in the urlader key value store.
maca 24:65:11:AE:CB:6B
macb 24:65:11:AE:CB:6C
macwlan 24:65:11:AE:CB:6D
macdsl 24:65:11:AE:CB:6E
Following the fritz_tffs call in 02_network it will be:
lan=$(fritz_tffs -n maca -i $(find_mtd_part "tffs (1)"))
wlan=$(fritz_tffs -n macwlan -i $(find_mtd_part "tffs (1)"))
FYI, the label mac is macwlan.
Does that answer your question?
Mathias
_______________________________________________
openwrt-devel mailing list
[email protected]
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
