Signed-off-by: J. Scott Heppler <[email protected]>
ramips: add support for TRENDnet TEW-810DR Exact hardware clone for the D-Link DIR-810L. See OpenWRT device pages and review the PCB photos, boot logs and MTP flash partitions. https://openwrt.org/toh/trendnet/trendnet_tew-810dr_1.0_1.1 https://openwrt.org/toh/d-link/dir-810l Specification: * MediaTek MT7620A (580 Mhz) * 8 MB of FLASH * 64 MB of RAM * 5x 10/100 Mbps Ethernet (1 WAN and 4 LAN) * UART header on PCB (57600 8n1) * 2x BiColor LED (GPIO-controlled) * 2x button - power and reset * U-boot bootloader Installation: The sysupgrade.bin image needs to have a cameo hardware ID appended with ncc_att_hwid. ncc_att_hwid is available in the GPL Source download for either the TEW-810DR or DIR-810L and is located at source/user/wolf/cameo/ncc/hostTools The invocation is: ncc_att_hwid -f tew-810-squashfs-factory.bin -a -m “TEW-810DR” -H “1.0R” -r “WW” -c “1.0” More information is available in the device page for TEW-810DR linked above The appended image can then be flash via the Web rescue interface 192.168.10.1 or TFTP's to the same IP address. Subsequent upgrades can be done using the Luci web interface or the ssh command line per the OpenWRT documentation --- .../ramips/dts/mt7620a_trendnet_tew-810dr.dts | 157 ++++++++++++++++++ target/linux/ramips/image/mt7620.mk | 10 ++ .../mt7620/base-files/etc/board.d/02_network | 3 +- 3 files changed, 169 insertions(+), 1 deletion(-) create mode 100644 target/linux/ramips/dts/mt7620a_trendnet_tew-810dr.dts diff --git a/target/linux/ramips/dts/mt7620a_trendnet_tew-810dr.dts b/target/linux/ramips/dts/mt7620a_trendnet_tew-810dr.dts new file mode 100644 index 0000000000..eb38110801 --- /dev/null +++ b/target/linux/ramips/dts/mt7620a_trendnet_tew-810dr.dts @@ -0,0 +1,157 @@ +/dts-v1/; + +#include "mt7620a.dtsi" + +#include <dt-bindings/gpio/gpio.h> +#include <dt-bindings/input/input.h> + +/ { + compatible = "trendnet,tew-810dr", "ralink,mt7620a-soc"; + model = "TRENDnet TEW-810DR"; + + aliases { + led-boot = &led_power_green; + led-failsafe = &led_power_green; + led-running = &led_power_green; + led-upgrade = &led_power_green; + label-mac-device = ðernet; + }; + + keys { + compatible = "gpio-keys"; + + reset { + label = "reset"; + gpios = <&gpio0 1 GPIO_ACTIVE_LOW>; + linux,code = <BTN_0>; + }; + + wps { + label = "wps"; + gpios = <&gpio0 2 GPIO_ACTIVE_LOW>; + linux,code = <BTN_0>; + }; + }; + + leds { + compatible = "gpio-leds"; + + led_power_green: power { + label = "dir-810l:green:power"; + gpios = <&gpio0 9 GPIO_ACTIVE_HIGH>; + }; + + wan { + label = "dir-810l:orange:wan"; + gpios = <&gpio0 12 GPIO_ACTIVE_HIGH>; + }; + + power2 { + label = "dir-810l:orange:power"; + gpios = <&gpio0 13 GPIO_ACTIVE_HIGH>; + }; + }; +}; + +&spi0 { + status = "okay"; + + m25p80@0 { + compatible = "jedec,spi-nor"; + reg = <0>; + spi-max-frequency = <10000000>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "u-boot"; + reg = <0x0 0x30000>; + read-only; + }; + + partition@30000 { + label = "u-boot-env"; + reg = <0x30000 0x10000>; + read-only; + }; + + factory: partition@40000 { + label = "factory"; + reg = <0x40000 0x10000>; + read-only; + }; + + factory5g: partition@50000 { + label = "factory5g"; + reg = <0x50000 0x10000>; + read-only; + }; + + partition@60000 { + label = "Wolf_Config"; + reg = <0x60000 0x10000>; + read-only; + }; + + partition@70000 { + label = "MyDlink"; + reg = <0x70000 0x80000>; + read-only; + }; + + partition@e0000 { + label = "Jffs2"; + reg = <0xe0000 0x80000>; + read-only; + }; + + partition@170000 { + compatible = "denx,uimage"; + label = "firmware"; + reg = <0x170000 0x690000>; + }; + }; + }; +}; + +&state_default { + gpio { + ralink,group = "mdio", "rgmii1", "i2c", "wled", "uartf"; + ralink,function = "gpio"; + }; +}; + +ðernet { + mtd-mac-address = <&factory 0x28>; + mediatek,portmap = "llllw"; +}; + +&gsw { + mediatek,port4 = "ephy"; + pinctrl-names = "default"; + pinctrl-0 = <&ephy_pins>; +}; + +&pcie { + status = "okay"; +}; + +&wmac { + ralink,mtd-eeprom = <&factory 0x0>; + pinctrl-names = "default"; + pinctrl-0 = <&pa_pins>; + mtd-mac-address = <&factory 0x28>; +}; + +&pcie0 { + wifi@0,0 { + reg = <0x0000 0 0 0 0>; + mediatek,mtd-eeprom = <&factory 0x8000>; + ieee80211-freq-limit = <5000000 6000000>; + mtd-mac-address = <&factory 0x28>; + mtd-mac-address-increment = <2>; + }; +}; diff --git a/target/linux/ramips/image/mt7620.mk b/target/linux/ramips/image/mt7620.mk index 3512a1c55a..71e4270a20 100644 --- a/target/linux/ramips/image/mt7620.mk +++ b/target/linux/ramips/image/mt7620.mk @@ -942,6 +942,16 @@ define Device/tplink_re200-v1 endef TARGET_DEVICES += tplink_re200-v1 +define Device/trendnet_tew-810dr + SOC := mt7620a + DEVICE_PACKAGES := kmod-mt76x0e + DEVICE_VENDOR := TRENDnet + DEVICE_MODEL := TEW-810DR + IMAGE_SIZE := 6720k + SUPPORTED_DEVICES += dir-810l +endef +TARGET_DEVICES += trendnet_tew-810dr + define Device/vonets_var11n-300 SOC := mt7620n IMAGE_SIZE := 3776k diff --git a/target/linux/ramips/mt7620/base-files/etc/board.d/02_network b/target/linux/ramips/mt7620/base-files/etc/board.d/02_network index 7397ddcc2c..a1b3f4bd0c 100755 --- a/target/linux/ramips/mt7620/base-files/etc/board.d/02_network +++ b/target/linux/ramips/mt7620/base-files/etc/board.d/02_network @@ -255,7 +255,8 @@ ramips_setup_macs() alfa-network,ac1200rm|\ dlink,dir-810l|\ phicomm,psg1218a|\ - phicomm,psg1218b) + phicomm,psg1218b|\ + trendnet,tew-810dr) wan_mac=$(macaddr_add "$(mtd_get_mac_binary factory 0x28)" 1) ;; alfa-network,r36m-e4g|\ -- 2.20.1 -- J. Scott Heppler _______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/mailman/listinfo/openwrt-devel
